It's a good idea to use a scrap piece of wood or the cutting mat under the leather while drilling so you don't damage any other surface. Drill small holes for the screws with the drill and drill bit where you marked the holes.Finished leather drawer pulls on my dresser Note: If you have a single hole in your drawer or cabinet, simply fold the leather strips in half and only use one brass screw each for looped leather cabinet pulls or drawer pulls. Then insert the screws into the holes and securely screw them in place with the washer and nuts.The washer and nut go onto the screw as pictured.) (Image 5 is just to show you how the screws will be kept secure in the back. cabinets, an appearance of plenty of room, bright and shining fix- tures. (It is important to make sure you drill small holes with appropriate sized drill bits so the head of the screw can’t slip through the holes when attached to your piece of furniture) Leather Market The following reports from manufacturers and whole- salers of. It’s a good idea to use a scrap piece of wood or the cutting mat under the leather while drilling so you don’t damage any other surface. You will need to take a couple of repeated cuts to get all the way through the thick leather. Use your cutting mat, sharp exacto/utility knife, and metal ruler to cut the piece of leather to the length of the drawer pull.This way you get the right length and a perfect fit. Make sure to slightly loop the leather up so you can fit a couple of fingers into the loop before marking the location of the holes onto the leather. If you have existing holes as I did, hold the leather piece on a drawer front so you can mark your holes.Before you start, make sure you use a cutting mat for this project and the right-sized drill bit and screw length for your specific drawer or cabinet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |